* Items such as LUT, DFF, MUX, ALU, IOB are displayed;
* Local wires, 1-2-4-8 wires are displayed;
* The clock spines, taps and branches are displayed with some caveats.
For now, you can not create a project in the GUI because of possible
conflict with another PR (about GW1NR-9C support), but you can specify
the board in the command line and load .JSON and .CST in the GUI.
Although ALUs are displayed, but the CIN and COUT wires are not. This is
still an unsolved problem.
Signed-off-by: YRabbit <rabbit@yrabbit.cyou>
Some models have I/O cells that are IOBUFs, and other types (IBUFs and
OBUFs) are obtained by feeding 1 or 0 to the OEN input. This is done
with general-purpose routing so it's best to do it here to avoid
conflicts.
For this purpose, in the new bases, these special cells are of type IOBS
(IOB Simplified).
The proposed changes are compatible with bases of previous versions of
Apycula and do not require changing .CST constraint files.
Signed-off-by: YRabbit <rabbit@yrabbit.cyou>
- Both the mode used by yosys and all Gowin primitive modes are supported.
- The ALU always starts with a zero slice.
- The maximum length of the ALU chain is limited to one line of the chip.
Signed-off-by: YRabbit <rabbit@yrabbit.cyou>
* A hardwired MUX within each logical cell is used.
* The delay is equal 0.
* No user placement constraints.
* The output route contains dummy PIPs. They are ignored by gowin_pack, but it may be worth removing them.
Signed-off-by: YRabbit <rabbit@yrabbit.cyou>
