Uses the information of the special input pins for the PLL in the
current chip. If such pins are involved, no routing is performed and
information about the use of implicit wires is passed to the packer.
The RESET and RESET_P inputs are now also disabled if they are connected
to VSS/VCC.
Signed-off-by: YRabbit <rabbit@yrabbit.cyou>
The rPLL primitive for the simplest chip (GW1N-1) in the family is
processed. All parameters of the primitive are passed on to gowin_pack,
and general-purpose wires are used for routing outputs of the primitive.
Compatible with older versions of apicula, but in this case will refuse
to place the new primitive.
Signed-off-by: YRabbit <rabbit@yrabbit.cyou>
There is no need to multiply item names, it is a rudiment of my very
first addition to nextpnr.
Fully compatible with older versions of Apicula.
Note: the cosmetic changes in lines with RAM are not my initiative, but
the result of applying clang-format.
Signed-off-by: YRabbit <rabbit@yrabbit.cyou>
- Both the mode used by yosys and all Gowin primitive modes are supported.
- The ALU always starts with a zero slice.
- The maximum length of the ALU chain is limited to one line of the chip.
Signed-off-by: YRabbit <rabbit@yrabbit.cyou>
* A hardwired MUX within each logical cell is used.
* The delay is equal 0.
* No user placement constraints.
* The output route contains dummy PIPs. They are ignored by gowin_pack, but it may be worth removing them.
Signed-off-by: YRabbit <rabbit@yrabbit.cyou>
