#!/bin/sh

# This is a sample, you should rewrite it according to your chip #
# clock will be closed at uboot, so you needn't call it!

clk_close()
{
	# Below clock operation is all from Hi3516A, you should modify by datasheet!
	echo "clock close operation done!"
}

# open module clock while you need it!
clk_cfg()
{
	himm 0x2003002c 0xc4003;	# VICAP, ISP unreset & clock enable, Sensor clock enable, clk reverse
	himm 0x20030034 0x64ff4;	# 6bit LCD
	#himm 0x20030034 0x164ff4;	# 8bit LCD
	#himm 0x20030034 0xff4       # bt656
	
	himm 0x20030040 0x2000;		# AVC unreset, code also config
	himm 0x20030048 0x2;		# VPSS unreset, code also config
	himm 0x20030058 0x2;		# TDE  unreset
	himm 0x2003005c 0x2;		#VGS
	himm 0x20030060 0x2;		# JPGE unreset
	#himm 0x20030068 0x02000000; # LCD 27M:0x04000000, 13.5M:0x02000000
	himm 0x2003006c 0xa;		# IVE/HASH  unreset
	himm 0x2003007c 0x2;		# Cipher
	himm 0x200300d4 0x7;        # GZIP
	himm 0x200300d8 0x2a;       # DDRTĦ˘EfuseĦ˘DMA 
	
	himm 0x2003008c 0x2;		# AIO unreset and clock enable,m/f/bclk config in code.
	himm 0x20030100 0x20;       # RSA
	himm 0x20030104 0x0;		# AVC-148.5M VGS-148.5M VPSS-99M


	# USB not set
	# SDIO not set 
	# SFC not set 
	# NAND not set
	# RTC use external clk	
	# PWM not set					 #(PERI_CRG38)himm 0x20030038 0x2        
	# DMAC not set 				 #(PERI_CRG56)himm 0x200300E0 0x2        
	# SPI not set 
	# I2C not set
	# SENSE CLK not set 
	# WDG not set 

	echo "clock configure operation done!"
}

#clk_close
clk_cfg