zcy
/
pluto_hdl_adi
1
0
Fork 0
Code Issues Pull Requests Packages Projects Releases Wiki Activity
pluto_hdl_adi/projects/adrv9001/a10soc/system_qsys.tcl

20 lines
597 B
Tcl
Raw Normal View History

adrv9001/a10soc: Initial version This project supports CMOS mode only.
2020-08-03 08:31:43 +00:00
source $ad_hdl_dir/projects/scripts/adi_pd.tcl
source $ad_hdl_dir/projects/common/a10soc/a10soc_system_qsys.tcl
Updated the makefiles to build the projects in subdirectories based on the build parameters. Running 'make' will build the default project directly in the project folder (like it did before) Running 'make RX_LANE_RATE=15 TX_LANE_RATE=15' will build the project inside the 'RXRATE15_TXRATE15' subdirectory. Running 'make CFG=cfg/test_config.txt" will use the variables found inside the configuration file and build the project inside the 'test_config' subdirectory. Running 'make clean' will clean the default project only. Running 'make CFG=cfg/test_config.txt clean' will clean the 'testconfig' build. Running 'make clean-all' will delete all the built configurations and libraries. Note that the 'JESD' and 'LANE' words from the parameter names are stripped. Signed-off-by: Bogdan Luncan <bogdan.luncan@analog.com>
2022-09-23 09:28:22 +00:00
if [info exists ad_project_dir] {
source ../../common/adrv9001_qsys.tcl
} else {
source ../common/adrv9001_qsys.tcl
}
adrv9001/a10soc: Initial version This project supports CMOS mode only.
2020-08-03 08:31:43 +00:00
adrv9001:a10soc:system_qsys.tcl: set clock polarity to 0 For fixing "Failed to reset the device and set SPI Config" error, both clockPolarity and clockPhase should be disabled or both enabled. By default both are unset. Signed-off-by: Stefan Raus <stefan.raus@analog.com>
2021-06-15 14:49:22 +00:00
set_instance_parameter_value sys_spi {clockPolarity} {0}
adrv9001/a10soc: Initial version This project supports CMOS mode only.
2020-08-03 08:31:43 +00:00
#system ID
set_instance_parameter_value axi_sysid_0 {ROM_ADDR_BITS} {9}
set_instance_parameter_value rom_sys_0 {ROM_ADDR_BITS} {9}
set_instance_parameter_value rom_sys_0 {PATH_TO_FILE} "[pwd]/mem_init_sys.txt"
set sys_cstring "sys rom custom string placeholder";
sysid_gen_sys_init_file $sys_cstring;