The FMCOMMS1 meets timing on ZED/ZC702 only if the phys_opt_design step
is part of the implmentation flow, with the Explore argument.
"This step performs physical optimizations such as timing-driven
replicaiton of high fanouts nets to improve timing results"
During an ID sync the request_id might increment, we should not generate a
response in this case. Since the ID sync only happens when the core is disabled
check that the core is enabled before generating a response.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
The pending_burst signal and the expression id != request_id are almost
identical. pending_burst goes high with a delay of one clock cycle, but the
important thing is that it goes low on the same clock cycle as the expression.
By using pending_burst here instead of 'id != request_id' we can reduce the
fanout of the 'id' register and improve the timing of the core.
ZC706 runs rx_clk at 250 MHz.
ZC702 and ZED run rx_clk at 200 MHz due to slower fabric.
The ZC702 and ZED projects need init_user in the boot procedure in order for the HP Ports to work correctly.
Both DDS and DMA mode work.
The ILA can not work at 250MHz on ZED/ZC702. Because of this, the data
path was modified from 28bits@250MHz to 56bits@125MHz, by using a FIFO.
The ZED/ZC702 max BUFG frequency is 464MHz, which corresponds to a 2.16
period so the constraints were modified accordingly.
Vivado doesn't handle the case where we use symbolic constants for the default
value properly, so update this to use plain integers.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
There were a few place in the core where it assumed a 64-bit wide bus. Make this
configurable using parameters. The patch also adds support for having different
DMA bus widths on the source and destination side.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
ZC702: Removed invalid address segments. Changed the constraints
for adc_clk to minimum possible value in order to meet timing.
ZED: Change the constraints for adc_clk to minimum possible value, in
order to meet timing
AXI_AD9643: Corrected the number of bits in the adc_mon_data bus
If the address generator is disabled the very same cycle as it tries to put a
new address on the bus, it will keep sending this address forever and the core
will lock up
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Right now there is always a period of one clock cycle where we can not transfer
any data when switching between two transfers. This patch modifies the data
mover to allow for zero latency. This fixes problems on the FMCOMMS1 platform
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Istvan Csomortani
Adrian Costina
Lars-Peter Clausen
ATofan
Rejeesh Kutty