Some designs choose to swap the positive and negative side of the of the
JESD204 lanes. One reason for this would be because it can simplify the
PCB layout. The polarity is in most cases also only applied to a subset of
the used lanes.
Add support for this to the adi_jesd204 and jesd204_phy for Altera modules.
This done by adding new parameter to the modules that allows to specify a
per lane polarity inversion. Each bit in the parameter corresponds to one
lane. If the bit is set the polarity is inverted for his lane. E.g. setting
the parameter to 0xc will invert the 3rd and 4th lane.
The setting is forwarded depending on whether soft or hard PCS is used to
either the soft PCS module or the transceiver block itself.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Add a wrapper that instantiates the Arria10 Native PHY and configures it
for JESD204 operation. The datapath width is set to 4 octets per beat.
The maximum lane rate that is achievable with hard-logic PCS included in
the PHY is below the requirements of the JESD204 for some of the PHY speed
grades. For projects that require a lane rate that is higher than what the
hard-logic PCS can support a soft-logic PCS module can be instantiated. The
external interface of the jesd204_phy is identical regardless of whether
soft- or hard-logic PCS is used.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Lars-Peter Clausen
Istvan Csomortani