- fixed constraints
- updated interrupt system
- used ad_iobuf
- The XADC was removed because the XADC IPI generates vaux inputs 0 and 10 even if 0 and 8 are selected
Reset generator's external reset signal was active low, but the GT reset is active high, and both the DDR controller and FIFO2S were in reset.
Therefore the external reset active state is changed to active high. This setup in general is made by the tool automatically, in order to do it correctly, need to
set this two property of the reset generator.
There can be a rather high latency between the last byte of a burst has been send and the time the response for the burst is received. Running at high samplerates this can cause the internal DMA store and forward FIFO to fill up and subsequently stall the DMA pipeline and drop samples. To better cope with the situation double the size of the internal FIFO. Also increase the clock of the AXI bus to be able to accommodate a samplerate of 310MHz.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
The axi_dmac supports native AXI3, there is no need to add a interconnect
for protocol conversion between it and the HP port.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
The scripts generating the projects files typically only work correctly with
one specific version of Vivado. If a incorrect version is used the script
may fail at some point with a cryptic error message or may not fail but
create a bitstream that is not working as expected, e.g. unconnected
signals, etc. This patch adds a version check to adi_project_create that
will error out early on stating that the wrong version of Vivado was used
and which is the right version to use.
By default the required version will be the version that is required by the
common scripts. Individual projects can overwrite the required version by
setting the REQUIRED_VIVADO_VERSION variable to the required version or can
bypass the version check completely by setting the IGNORE_VERSION_CHECK
variable to 1.
Callers of the script can also disable the version check by setting the
ADI_IGNORE_VERSION_CHECK environment variable.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
- increased the DMA FIFOs to 64
- added axi slices to the source and destination for DMAs
- for microblaze systems, increade the ad9643 dma data width at destination
- removed sys_fmc_dma_clk and used the sys_200m_clk instead for DMA data transfer
Rejeesh Kutty
Michael Hennerich
Adrian Costina
Istvan Csomortani
Lars-Peter Clausen