28aea82952
fmcomms2_zc702: Add SPI and GPIO interface for FREQCVT
2015-07-22 10:16:04 +03:00
0102e3e02c
fmcomms2_ALL: Preserve backward compatibility for ENABLE/TXNRX control
...
By default the ENABLE/TXNRX pins are controlled by GPIOs, if the TDD module is enabled, the TDD FSM will take over the control of these two pins.
2015-07-01 13:54:01 +03:00
a6cae6b477
iobuf: do is a system verilog keyword
2015-05-21 14:06:17 -04:00
9dac22c814
fmcomms2: ZC702 fixed GPIOs in top file
2015-04-02 15:30:41 +03:00
f0d08abe03
fmcomms2: Fix system_top.v for a few carrier
...
Interrupts are connected inside IPI. Fix system_top for zed, zc702, zc706 and kc705.
2015-03-18 10:37:24 +02:00
70e1d13a7b
fmcomms2: Updated project
2015-03-13 12:49:17 +02:00
ad08c62b36
fmcomms2: Updated zc702 project. Updated interrupts. Updated constraints
2014-11-07 14:01:55 +02:00
f528873fa9
fmcomms2: Add an additional SPI interface for up/down converter board
...
Supported carriers are: ZC706, ZC702 and Zed.
2014-10-10 18:47:07 +03:00
ca4c961891
fmcomms2: Use ad_iobuf instance on system_top
...
Use ad_iobuf instance on system top, instead of separate IOBUF instances.
2014-10-10 18:45:39 +03:00
e21d26e456
fmcomms2: Cosmetic changes
...
Get rid of unwanted whitespaces.
2014-10-10 18:25:17 +03:00
2c898bf3a2
Added ZC706, ZC702 and ZED FMCOMMS2 Vivado Project
...
ZC706 runs rx_clk at 250 MHz.
ZC702 and ZED run rx_clk at 200 MHz due to slower fabric.
The ZC702 and ZED projects need init_user in the boot procedure in order for the HP Ports to work correctly.
Both DDS and DMA mode work.
2014-03-18 15:27:42 +02:00
Istvan Csomortani
Rejeesh Kutty
Adrian Costina
ATofan