977d9d0624
Merge branch 'hdl_2015_r2' into dev
...
Conflicts:
projects/daq1/common/daq1_spi.v
2016-03-02 13:52:15 +02:00
40fb68dfd5
ad9265, ad9434, ad9467, daq1, daq2, daq3, fmcadc2, fmcadc4, fmcadc5, fmcjesdadc1, fmcomms6, fmcomms7, usdrx1: updated common spi module so that spi streaming is possible
2016-03-02 13:39:37 +02:00
becc23a69b
daq2: Modified common spi module so that spi streaming is possible
...
- stop incrementing spi_count after the instruction cycle
2016-03-01 17:25:58 +02:00
f7e490c2b3
hdlmake.pl updates
2016-02-26 13:46:11 -05:00
e012d0519b
Merge remote-tracking branch 'origin/hdl_2015_r2' into dev
2016-02-26 13:39:39 -05:00
f6e64e42b0
kcu105: add ethernet idelaycntrl
2016-02-26 13:19:49 -05:00
59313f3c90
daq1: ADC DMA must be in none-cyclic mode
2016-02-24 14:37:19 +02:00
c0a559a9b1
daq1: Fix some typos in the SPI wrapper
2016-02-24 14:31:56 +02:00
8ccd8d87bb
daq2: A10GX, increase analog/digital reset durations
...
- reset the xcvr_rst_cntrl only from the axi_jesd_xcvr
- checked separate RX/TX reset per channel
2016-02-23 11:41:38 +02:00
89f7aadfb1
fmcjesdadc1: A5GT, connected xcvr_rxt_cntrl reset input to the axi_jesd_xcvr reset output
...
This will allow for the transceivers to be reset by the axi_jesd_xcvr core
2016-02-23 11:31:07 +02:00
4fb6589b2d
pzsdr/ccfmc: add fan controls
2016-02-19 16:40:54 -05:00
377461e0d4
Merge branch 'hdl_2015_r2' into dev
2016-02-19 14:15:27 +02:00
0f37dd6424
fmcjesdadc1: Fixed project
...
- changed system_project.tcl so that all base designs to be included
- changed DMA properties to take into consideration the new parameter names
- changed reset bridges to asynchronous
- increased maximum burst size of the DMA bridge
- changed the data_width of the memory bus to 256, as with 512 timing violations may occur
- changed base addresses for the base system to be the same as in the previous release
2016-02-19 14:09:57 +02:00
ce760eb691
fmcadc2- add adf4355 access
2016-02-18 16:17:33 -05:00
a8e9d72273
adc/dac - prefix parameters
2016-02-17 14:16:04 -05:00
d94f157454
arradio: Changed ADC/DAC DMA address length to 24 bit
2016-02-16 15:27:51 +02:00
43e03ca6f7
arradio: Updated project
...
- made the reset bridges asynchronous
- connected the arradio gpio to the CPU interconnect
2016-02-16 14:50:23 +02:00
5518c47ca4
daq1_cpld: Set Input and tristate I/O termination mode to FLOAT
2016-02-15 19:27:59 +02:00
051ac307e6
daq1_cpld: Do not forward the first eight clock cycles of fmc_spi_sclk to sclk
2016-02-15 19:26:58 +02:00
9370246cfa
daq1: Fix bugs on CPLD design
...
Fix the CSN forwarding.
2016-02-12 16:59:09 +02:00
5ed2c0b599
daq1: Update CPLD constraints file
2016-02-12 16:54:36 +02:00
aa2ff0223a
daq1: Update CPLD design
...
+ SPI counter counts on negative edge of the SPI_CLK
+ Shift register for read, shifting MSB first
+ Fix write access logic
+ Update the internal register addresses
2016-02-12 14:45:18 +02:00
e1c5d6a8f7
axi_ad9684: Fix constraint file
2016-02-12 14:38:59 +02:00
c32d7147d5
daq1 : There is a single CSN from master
2016-02-12 14:38:32 +02:00
9675df15c6
daq1_zc706: Update constraints file
2016-02-12 14:37:02 +02:00
a747fad540
axi_ad9361: tx_valid must be controlled by the TDD controller
2016-02-12 14:33:34 +02:00
e381d5170c
util_tdd_sync: Update the synchronization interface
...
Simplify the synchronization interface, there is one signal line between the synchronization module and transceiver core.
2016-02-12 14:27:37 +02:00
1c3795ad02
Update .gitattributes
...
Add xise file extension to .gitattributes
2016-02-12 14:27:35 +02:00
61f9f72a75
fmcjesdadc1: Updated VC707 project for maximum throughput from DMA to DDR
...
- Increased the DMAs internal FIFO
2016-02-09 12:30:56 +02:00
c431adb793
fmcjesdadc1: Updated KC705 project for maximum throughput from DMA to DDR
...
- Increased the DMA internal FIFO
2016-02-09 12:00:27 +02:00
ad9ecbbbb6
daq2: Updated a10gx project to quartus 15.1.1
2016-02-05 17:43:05 +02:00
0d67af370f
util_upack: Fixed problem when dac valid isn't continuous from the DAC
...
In cases when the dac_valid_ from the DAC is not continuous, in some situations
there were two dac_valid pulses sent to the DMA.
2016-02-04 13:03:46 +02:00
bb62f6d225
pzsdr1- updates
2016-02-02 12:34:09 -05:00
41b6ebeeaf
pzsdr1- updates
2016-02-02 12:33:55 -05:00
b147e9c94a
pzsdr1- updates
2016-02-02 12:33:01 -05:00
170295161f
pzsdr1- xdc
2016-01-26 11:19:00 -05:00
bcac3eef4d
pzsdr1- initial commit
2016-01-25 16:07:33 -05:00
44a382fc69
pzsdr1-added
2016-01-25 15:33:34 -05:00
e22d5d5c18
daq2: Fix clock constraints for KC705 and VC707
2016-01-22 19:09:57 +02:00
59fbd99fdb
fmcjesdadc1: Added clock constraint for the ADC path
2016-01-22 15:46:20 +02:00
dca39c26f9
ad6676evb: Added clock constraint for the ADC path
2016-01-22 15:45:16 +02:00
9cd0378003
fmcadc2: Added clock constraint for the ADC path
2016-01-22 15:44:04 +02:00
aa77af6bdf
daq1_cpld: Add ISE project file
...
This file, along with the project source files, is sufficient to open and implement in ISE Project Navigator.
2016-01-21 18:05:59 +02:00
4cc69c0cac
axi_ad9684: Add Makefile
2016-01-19 18:32:11 +02:00
c865dbf353
axi_ad9680: Fix channel instantiation
2016-01-19 12:49:45 +02:00
df3eefdca1
axi_ad9434: Update constraint file
2016-01-19 12:43:05 +02:00
8c69c9d2ce
daq1_zc706 : Update the project
...
+ Add AD9684 to the block design
+ Update the IO definitions
+ Update the CPLD design
+ Add 3wire SPI logic
2016-01-19 11:20:35 +02:00
d1e638349b
ad_serdes_clk : The reference clock selection line should by tied to 1
...
Just the CLKIN1 is used in the MMCM.
2016-01-19 11:18:00 +02:00
c6cfd1a2b6
axi_ad9684: Initial check in
2016-01-19 11:13:45 +02:00
ab99c4456a
ad9434_fmc: Delete unnecessary set_property call
...
HPx interface is activated by the ad_mem_hpx_interconnect process
2016-01-14 15:41:23 +02:00
Adrian Costina
Rejeesh Kutty
Istvan Csomortani
István Csomortáni