1db5f4696f
kcu105: isolate ddr-300M from interconnect-100M timing
2015-03-06 12:37:31 -05:00
8dfcbdfd48
gt_channel/gt_common: simulation parameter warning fix
2015-03-06 12:36:07 -05:00
57e1f0e334
gt_channel/gt_common: simulation parameter warning fix
2015-03-06 12:36:03 -05:00
da5b136f5a
daq2+base: board tcl updates
2015-03-05 10:56:36 -05:00
0ac1676318
daq2+base: board tcl updates
2015-03-05 10:56:36 -05:00
7fba7cc6e5
daq2+base: board tcl updates
2015-03-05 10:56:36 -05:00
af465cbc80
daq2+base: board tcl updates
2015-03-05 10:56:36 -05:00
1220b53c8c
daq2+base: board tcl updates
2015-03-05 10:56:36 -05:00
75c4228987
daq2+base: board tcl updates
2015-03-05 10:56:36 -05:00
605d23d3a4
daq2+base: board tcl updates
2015-03-05 10:56:36 -05:00
91765fdd82
daq2+base: board tcl updates
2015-03-05 10:56:36 -05:00
7bf4141a3f
daq2+base: board tcl updates
2015-03-05 10:56:36 -05:00
2d01955042
up_gt: change version dfe/lpm support
2015-03-05 09:47:16 -05:00
6995f63134
Add version check to adi_ip.tcl too.
2015-03-05 11:55:09 +02:00
bf1388b05e
kcu105: rev.d changes
2015-03-04 12:43:04 -05:00
e0f2ca8cdb
README: Update Vivado version number, 2014.4.1 is the new supported version
2015-03-03 09:48:13 +02:00
4f918cdce9
2014.4.1 ultrascale updates
2015-02-26 16:10:57 -05:00
847c2e049a
kcu105: removed lutram constraints
2015-02-26 16:09:55 -05:00
1613f7fb41
cftl_cip: Add util_pmod_fmeter IP to library
...
Frequency meter IP for CN0332.
2015-02-23 17:20:12 +02:00
abde4048e0
fmcomms1: Add extra AXI slice on ADC DMA path
...
Add a extra AXI slice on the ADC DMA data path to the HP interconnect to
improve the timing.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
2015-02-20 16:43:45 +01:00
b9d16a7eb1
scripts: renaming board parameters
2015-02-20 09:12:30 -05:00
65bda6505e
axi_dmac: Correctly handle shutdown for the request splitter
...
We need to make sure to not prematurely de-assert the s_valid signal for the
request splitter when disabling the DMAC. Otherwise it is possible that
under certain conditions the DMAC is disabled with a partially accepted
request and when it is enabled again it will continue in an inconsistent
state which can lead to transfer corruption or pipeline stalls.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
2015-02-19 17:22:23 +01:00
731e1c0996
axi_dmac: Use internal enable signal for the request generator
...
All components should use the internal 'do_enable' signal instead of the
external 'enable' signal. The former correctly incorporates the shutdown
sequence and does not get asserted again until the shutdown has been
completed. Using the external signal can cause problems when it is disabled
and enabled again in close proximity.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
2015-02-19 17:22:23 +01:00
582ea06918
axi_dmac: request_generator: Stop generating requests when disabled
...
Currently when the DMAC gets disabled the request_generator will still
generate all remaining burst requests for the currently active transfer.
While these requests will be ignored by the source and destination component
this can still take a fair amount of time for long transfers.
So just stop generating burst requests once the DMAC is being disabled.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
2015-02-19 17:22:23 +01:00
aa594e15f3
axi_dmac: fifo_inf: Handle overflow and underflow correctly
...
Refactor the fifo_inf modules to always correctly generate the underflow and
overflow status signals. Before it was possible that in some cases they
were not generated when they should have been.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
2015-02-19 17:22:21 +01:00
6edcaa478a
adi_ip: updates for 2014.4
2015-02-19 11:11:39 -05:00
288f5378ff
rfsom: schematic changes
2015-02-18 14:32:41 -05:00
93e2bcd911
rfsom: schematic changes
2015-02-18 14:32:30 -05:00
383cf3b3a3
rfsom: schematic changes
2015-02-18 14:32:20 -05:00
d2e9b1fe03
rfsom: schematic changes
2015-02-18 14:32:04 -05:00
3113abf038
cftl_cip: Add gpio counter for CN0332
...
Add a counter core to the design, to support the CN0332 pmod with a speed sensor.
Change a naming for the custom cores.
2015-02-18 18:24:46 +02:00
9cdec38532
gt- report device type
2015-02-17 11:43:57 -05:00
2442b6e929
gt- report device type
2015-02-17 11:43:50 -05:00
fccadcec31
jesd_gt: lpm/dfe programmable
2015-02-13 11:33:25 -05:00
de043ce130
gt_channel: lpm/dfe programmable
2015-02-13 11:33:04 -05:00
870ebdb562
up_gt: support lpm mode
2015-02-12 16:21:11 -05:00
1e7c9a3924
gt_es: support lpm mode - 2/2
2015-02-12 16:20:43 -05:00
0a8e6f62ef
gt_es: support lpm mode - 1/2
2015-02-12 15:15:18 -05:00
c908cea801
Merge branch 'master' into dev
2015-02-09 10:01:39 +02:00
9e2e2ef44e
xfer-logic: stretch toggles to allow capture
2015-02-06 22:15:16 -05:00
e9231c8f36
xfer-logic: stretch toggles to allow capture
2015-02-06 22:15:14 -05:00
e111e1336e
conflicts-
2015-02-06 22:14:21 -05:00
8839c8b18c
xfer-logic: stretch toggles to allow capture
2015-02-06 22:07:00 -05:00
8050a14bd8
xfer-logic: stretch toggles to allow capture
2015-02-06 22:06:56 -05:00
518d842af9
upack: initial commit
2015-02-06 15:15:33 -05:00
2d607d765b
cftl_cip: Add a clock input to the device core, for the SPI clock.
...
This clock can be adjustable from the system_project.tcl
2015-02-04 14:55:17 +02:00
d02c21b426
util_pmod_adc: General update
...
Redesign the state machine, rename constant and variable names, add notes and description.
2015-02-04 14:49:16 +02:00
996e1b7970
rfsom: constraint updates
2015-02-03 14:20:34 -05:00
890bb1da75
daq2: Add support for VC707
2015-01-29 18:33:27 +02:00
fd2ab02174
cftl_std: Added in the constraint file comments regarding supported CFTLs
2015-01-29 16:27:43 +02:00
Rejeesh Kutty
Istvan Csomortani
Lars-Peter Clausen
Adrian Costina