This helper module can be used to make sure that a reset signal is de-asserted
synchronously to a clock signal. This is e.g. required by the AXI spec.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
- Add an auxiliary cpu interconnect
- Add an auxiliary interrupt concatenation module
- Add new MIG file, current frequency of the DDR interface is 100
Mhz
- Memory interconnect optimisation strategy is 'Maximize
Performance'
The FMCOMMS1 meets timing on ZED/ZC702 only if the phys_opt_design step
is part of the implmentation flow, with the Explore argument.
"This step performs physical optimizations such as timing-driven
replicaiton of high fanouts nets to improve timing results"
During an ID sync the request_id might increment, we should not generate a
response in this case. Since the ID sync only happens when the core is disabled
check that the core is enabled before generating a response.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
The pending_burst signal and the expression id != request_id are almost
identical. pending_burst goes high with a delay of one clock cycle, but the
important thing is that it goes low on the same clock cycle as the expression.
By using pending_burst here instead of 'id != request_id' we can reduce the
fanout of the 'id' register and improve the timing of the core.
ZC706 runs rx_clk at 250 MHz.
ZC702 and ZED run rx_clk at 200 MHz due to slower fabric.
The ZC702 and ZED projects need init_user in the boot procedure in order for the HP Ports to work correctly.
Both DDS and DMA mode work.
The ILA can not work at 250MHz on ZED/ZC702. Because of this, the data
path was modified from 28bits@250MHz to 56bits@125MHz, by using a FIFO.
The ZED/ZC702 max BUFG frequency is 464MHz, which corresponds to a 2.16
period so the constraints were modified accordingly.
Vivado doesn't handle the case where we use symbolic constants for the default
value properly, so update this to use plain integers.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
There were a few place in the core where it assumed a 64-bit wide bus. Make this
configurable using parameters. The patch also adds support for having different
DMA bus widths on the source and destination side.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
ZC702: Removed invalid address segments. Changed the constraints
for adc_clk to minimum possible value in order to meet timing.
ZED: Change the constraints for adc_clk to minimum possible value, in
order to meet timing
AXI_AD9643: Corrected the number of bits in the adc_mon_data bus
Istvan Csomortani
Lars-Peter Clausen
Rejeesh Kutty
Adrian Costina
ATofan