Add a parameter to the ad_xcvrcon function that allows to provide a mapping
between logical and physical lanes. By default if no lane map is provided
the logial and physical lanes are mapped 1-to-1. If a lane map is provided
logical lane $n is mapped onto physical lane $lane_map[$n].
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Let the ad_xcvrcon handle the ADI JESD204 link layer cores. The function
will detect the JESD204 core vendor and connect the appropriate signals
based on it. This means it can still be used with the Xilinx JESD204 core
as well.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
When trying to use ad_cpu_interconnect to connect to a AXI interface that
is a outer port of a hierarchy this will fail at the moment as it kind find
the matching clock and reset signals.
Add support for traversing into the hierarchy and find the final target AXI
port inside the hierarchy. Then find the matching clock and reset and
traverse them back the corresponding hierarchy outer ports.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
In case of axi_interconnects, when just one slave and master interface is
active, the 'Interconnect Optimization Strategy' is disabled. So this
parameter should be set just if there is more than one slave interface.
Sometimes the find_bd_objs does not do its job, so need to double check that the interface clock is already connected to the p_clock or not.
Not sure about the cause of this behavior, need more investigation. Issue was found first at KC705 base design.
Lars-Peter Clausen
Rejeesh Kutty
Istvan Csomortani
Adrian Costina
Shrutika Redkar