57cfb7cfb1
hdl/library: Update the IP parameters
...
The following IP parameters were renamed:
PCORE_ID --> ID
PCORE_DEVTYPE --> DEVICE_TYPE
PCORE_IODELAY_GROUP --> IO_DELAY_GROUP
CH_DW --> CHANNEL_DATA_WIDTH
CH_CNT --> NUM_OF_CHANNELS
PCORE_BUFTYPE --> DEVICE_TYPE
PCORE_ADC_DP_DISABLE --> ADC_DATAPATH_DISABLE
CHID --> CHANNEL_ID
PCORE_DEVICE_TYPE --> DEVICE_TYPE
PCORE_MMCM_BUFIO_N --> MMCM_BUFIO_N
PCORE_SERDES_DDR_N --> SERDES_DDR_N
PCORE_DAC_DP_DISABLE --> DAC_DATAPATH_DISABLE
DP_DISABLE --> DATAPATH_DISABLE
PCORE_DAC_IODELAY_ENABLE --> DAC_IODELAY_ENABLE
C_BIG_ENDIAN --> BIG_ENDIAN
C_M_DATA_WIDTH --> MASTER_DATA_WIDTH
C_S_DATA_WIDTH --> SLAVE_DATA_WIDTH
NUM_CHANNELS --> NUM_OF_CHANNELS
CHANNELS --> NUM_OF_CHANNELS
PCORE_4L_2L_N -->QUAD_OR_DUAL_N
C_ADDRESS_WIDTH --> ADDRESS_WIDTH
C_DATA_WIDTH --> DATA_WIDTH
C_CLKS_ASYNC --> CLKS_ASYNC
PCORE_QUAD_DUAL_N --> QUAD_DUAL_N
NUM_CS --> NUM_OF_CS
PCORE_DAC_CHANNEL_ID --> DAC_CHANNEL_ID
PCORE_ADC_CHANNEL_ID --> ADC_CHANNEL_ID
PCORE_CLK0_DIV --> CLK0_DIV
PCORE_CLK1_DIV --> CLK1_DIV
PCORE_CLKIN_PERIOD --> CLKIN_PERIOD
PCORE_VCO_DIV --> VCO_DIV
PCORE_Cr_Cb_N --> CR_CB_N
PCORE_VCO_MUL --> VCO_MUL
PCORE_EMBEDDED_SYNC --> EMBEDDED_SYNC
PCORE_AXI_ID_WIDTH --> AXI_ID_WIDTH
PCORE_ADDR_WIDTH --> ADDRESS_WIDTH
DADATA_WIDTH --> DATA_WIDTH
NUM_OF_NUM_OF_CHANNEL --> NUM_OF_CHANNELS
DEBOUNCER_LEN --> DEBOUNCER_LENGTH
ADDR_WIDTH --> ADDRESS_WIDTH
C_S_AXIS_REGISTERED --> S_AXIS_REGISTERED
Cr_Cb_N --> CR_CB_N
ADDATA_WIDTH --> ADC_DATA_WIDTH
BUFTYPE --> DEVICE_TYPE
NUM_BITS --> NUM_OF_BITS
WIDTH_A --> A_DATA_WIDTH
WIDTH_B --> B_DATA_WIDTH
CH_OCNT --> NUM_OF_CHANNELS_O
M_CNT --> NUM_OF_CHANNELS_M
P_CNT --> NUM_OF_CHANNELS_P
CH_ICNT --> NUM_OF_CHANNELS_I
CH_MCNT --> NUM_OF_CHANNELS_M
4L_2L_N --> QUAD_OR_DUAL_N
SPI_CLK_ASYNC --> ASYNC_SPI_CLK
MMCM_BUFIO_N --> MMCM_OR_BUFIO_N
SERDES_DDR_N --> SERDES_OR_DDR_N
CLK_ASYNC --> ASYNC_CLK
CLKS_ASYNC --> ASYNC_CLK
SERDES --> SERDES_OR_DDR_N
GTH_GTX_N --> GTH_OR_GTX_N
IF_TYPE --> DDR_OR_SDR_N
PARALLEL_WIDTH --> DATA_WIDTH
ADD_SUB --> ADD_OR_SUB_N
A_WIDTH --> A_DATA_WIDTH
CONST_VALUE --> B_DATA_VALUE
IO_BASEADDR --> BASE_ADDRESS
IO_WIDTH --> DATA_WIDTH
QUAD_DUAL_N --> QUAD_OR_DUAL_N
AXI_ADDRLIMIT --> AXI_ADDRESS_LIMIT
ADDRESS_A_DATA_WIDTH --> A_ADDRESS_WIDTH
ADDRESS_B_DATA_WIDTH --> B_ADDRESS_WIDTH
MODE_OF_ENABLE --> CONTROL_TYPE
CONTROL_TYPE --> LEVEL_OR_PULSE_N
IQSEL --> Q_OR_I_N
MMCM --> MMCM_OR_BUFR_N
2015-08-19 14:11:47 +03:00
a7da779b94
Makefile: Updated Makefiles
2015-07-16 18:19:42 +03:00
6862655b0d
Add .gitattributes file
...
Add .gitattributes file which sets up the eol encoding handling. This will
make sure that we get a uniform eol encoding across different operating
systems.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
2015-06-26 11:07:10 +02:00
142f802f54
adv7511: Fixed vc707 ethernet connections
2015-06-16 16:26:58 +03:00
71b5004b25
projects- drp moved to up-clock domain
2015-06-01 14:57:59 -04:00
a6cae6b477
iobuf: do is a system verilog keyword
2015-05-21 14:06:17 -04:00
6b9906b22b
Refresh Makefiles
...
Re-generate the Makefiles after a small update to the generation script:
- Entries are sorted alphabetically
- Empty dependency lines are skipped
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
2015-05-21 14:21:54 +02:00
c19749361d
Makefiles: Updated makefiles to have as a result the programming file instead of the project file.
...
Also fixed altera projects dependencies
2015-05-18 17:22:46 +03:00
d515ab1b61
adv7511: AC701, update project to work at full HD resolution
2015-05-08 18:53:47 +03:00
91279253ef
Makefiles: Added mig project file as a dependency for Microblaze based projects. Also updated usdrx1 a5gt Makefile
2015-05-08 15:31:40 +03:00
949abcdc8f
Makefile: Updated makefiles so that the project recipe does not depend on lib
2015-05-06 14:58:29 +03:00
95805f21fa
adv7511: Fixed system_top for mitx045 board
2015-05-05 10:08:11 +03:00
3517b6941c
adv7511:kcu105, axi_hdmi_tx, axi_spdif_tx constraints modified so they apply to ultrascale
2015-05-05 10:06:26 +03:00
e51edfbadb
adv7511: KC705 mdio pin name fix
2015-04-27 11:21:36 +03:00
1bb5b6e55f
adv7511: zc706: Fix ddr and fixed_io signal names
...
The toplevel input/output signal names are lower case, but the signals
connected to the system_wrapper are upper case. Since verilog is case
sensitive this leaves the toplevel input/output signals unconnected. Fix
this by using lower case names everywhere.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
2015-04-23 14:33:47 +02:00
dc2b37bd0c
Makefile: Added top level Makefile. Modified behavior of clean and clean-all
...
Clean ran for a project will clean only the project files.
Clean-all ran for a project will clean also the library files on which the project depends.
The clean commands will only remove specific files and directories.
The top Makefile allows several options(per suggestion from jameyhicks):
make fmcomms1.zed will run "make all" in projects/fmcomms1/zed/
make clean will run "make clean" for all the projects
make clean-all will run "make clean" for all the projects and libraries
make lib will run "make all" for the library files
2015-04-17 17:22:38 +03:00
780455d68c
Makefile: Updated makefiles. Added makefiles for altera
2015-04-09 17:57:06 +03:00
5f8e9a74ea
makefile: updated
2015-04-07 16:32:01 -04:00
f79a152958
Makefiles: updated all makefiles adding clean functionality
2015-04-03 11:57:54 +03:00
d8ca123557
makefile: added
2015-04-01 16:28:48 -04:00
88676c8c00
makefile: added
2015-04-01 16:28:47 -04:00
786690cdae
makefile: added
2015-04-01 16:28:46 -04:00
861341df2d
makefile: added
2015-04-01 16:28:44 -04:00
69e817aed7
makefile: added
2015-04-01 16:28:43 -04:00
8595341c32
makefile: added
2015-04-01 16:28:42 -04:00
1c558f23db
makefile: added
2015-04-01 16:28:41 -04:00
d5562e6a63
makefile: added
2015-04-01 16:28:39 -04:00
47331d951a
makefile: added
2015-04-01 16:28:38 -04:00
7d1c715f09
adv7511_vc707: Fix system top.
2015-03-31 11:00:48 +03:00
4f69ae19c5
adv7511_mitx045: Update latest frame work.
2015-03-30 17:54:37 +03:00
fcb163062f
adv7511 : Fix top for kcu105 and kc705
2015-03-30 16:21:38 +03:00
c00633d1ac
adv7511_ac701: Update project and common files to the new framework.
2015-03-30 15:23:26 +03:00
166c78060c
adv7511_vc707: Fix system top.
2015-03-29 16:17:08 +03:00
7e539632e5
adv7511_kc705: Fix system top.
2015-03-29 16:16:11 +03:00
f1e542abe3
adv7511_vc707: Constraint file added.
2015-03-26 13:03:51 +02:00
2d05193093
adv7511_zc702: Update project to the new framework.
2015-03-26 12:20:31 +02:00
d1e4727066
adv7511_vc707: Update project to the new framework.
2015-03-26 12:20:30 +02:00
feb29d57a5
adv7511_kcu105: PCORE_DEVICE_TYPE is a carrier specific parameter.
...
Move the PCORE_DEVICE_TYPE parameter from common to system_bd.
2015-03-26 12:20:28 +02:00
7c289c8844
adv7511_kc705: Update project to the new framework.
2015-03-26 12:20:27 +02:00
7c921474bf
adv7511_zed: Update project to the new framework
2015-03-23 13:01:51 +02:00
b12187433d
adv7511_zc706: Interrupts and framework updates
2015-03-20 13:30:24 +02:00
18c03a57f8
adv7511/mb: added board files
2015-03-12 11:09:32 -04:00
7f462a1b34
adv7511/mb: added board files
2015-03-12 11:09:27 -04:00
15967f913f
adv7511/mb: added board files
2015-03-12 11:09:20 -04:00
8d0c3573cc
adv7511/kcu105: hdmi/spdif moved out of base design
2015-03-11 15:22:39 -04:00
491b67c13a
adv7511/kcu105: hdmi/spdif moved out of base design
2015-03-11 15:22:39 -04:00
09b916d0c7
kcu105/adv7511: moved hdmi/spdif out of base design
2015-03-10 16:15:13 -04:00
20b2c19987
kcu105/adv7511: moved hdmi/spdif out of base design
2015-03-10 16:15:11 -04:00
ad41d250a8
kcu105/adv7511: moved hdmi/spdif out of base design
2015-03-10 16:15:10 -04:00
47871287f3
kc705: Updated base project with linear flash. Updated all depending projects
2015-01-13 10:19:07 +02:00
Istvan Csomortani
Adrian Costina
Lars-Peter Clausen
Rejeesh Kutty