pluto_hdl_adi/projects/fmcjesdadc1/a5gt/system_top.v

254 lines
8.3 KiB
Verilog

// ***************************************************************************
// ***************************************************************************
// Copyright 2011(c) Analog Devices, Inc.
//
// All rights reserved.
//
// Redistribution and use in source and binary forms, with or without modification,
// are permitted provided that the following conditions are met:
// - Redistributions of source code must retain the above copyright
// notice, this list of conditions and the following disclaimer.
// - Redistributions in binary form must reproduce the above copyright
// notice, this list of conditions and the following disclaimer in
// the documentation and/or other materials provided with the
// distribution.
// - Neither the name of Analog Devices, Inc. nor the names of its
// contributors may be used to endorse or promote products derived
// from this software without specific prior written permission.
// - The use of this software may or may not infringe the patent rights
// of one or more patent holders. This license does not release you
// from the requirement that you obtain separate licenses from these
// patent holders to use this software.
// - Use of the software either in source or binary form, must be run
// on or directly connected to an Analog Devices Inc. component.
//
// THIS SOFTWARE IS PROVIDED BY ANALOG DEVICES "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES,
// INCLUDING, BUT NOT LIMITED TO, NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A
// PARTICULAR PURPOSE ARE DISCLAIMED.
//
// IN NO EVENT SHALL ANALOG DEVICES BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL,
// EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, INTELLECTUAL PROPERTY
// RIGHTS, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR
// BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT,
// STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF
// THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
// ***************************************************************************
// ***************************************************************************
`timescale 1ns/100ps
module system_top (
// clock and resets
input sys_clk,
input sys_resetn,
// ddr3
output ddr3_clk_p,
output ddr3_clk_n,
output [ 13:0] ddr3_a,
output [ 2:0] ddr3_ba,
output ddr3_cke,
output ddr3_cs_n,
output ddr3_odt,
output ddr3_reset_n,
output ddr3_we_n,
output ddr3_ras_n,
output ddr3_cas_n,
inout [ 7:0] ddr3_dqs_p,
inout [ 7:0] ddr3_dqs_n,
inout [ 63:0] ddr3_dq,
output [ 7:0] ddr3_dm,
input ddr3_rzq,
// ethernet
input eth_rx_clk,
input [ 3:0] eth_rx_data,
input eth_rx_cntrl,
output eth_tx_clk_out,
output [ 3:0] eth_tx_data,
output eth_tx_cntrl,
output eth_mdc,
input eth_mdio_i,
output eth_mdio_o,
output eth_mdio_t,
output eth_phy_resetn,
// board gpio
output [ 15:0] gpio_bd_o,
input [ 10:0] gpio_bd_i,
// lane interface
input ref_clk,
input [ 3:0] rx_data,
output rx_sync,
output rx_sysref,
// spi
output spi_csn,
output spi_clk,
inout spi_sdio);
// internal registers
reg [ 3:0] phy_rst_cnt = 0;
reg phy_rst_reg = 0;
// internal signals
wire sys_125m_clk;
wire sys_25m_clk;
wire sys_2m5_clk;
wire sys_cpu_clk;
wire sys_cpu_mem_resetn;
wire sys_cpu_resetn;
wire sys_pll_locked;
wire eth_tx_clk;
wire eth_tx_mode_1g;
wire eth_tx_mode_10m_100m_n;
wire rx_clk;
wire [ 3:0] rx_ip_sof;
wire [127:0] rx_ip_data;
wire spi_mosi;
wire spi_miso;
wire [ 63:0] gpio_i;
wire [ 63:0] gpio_o;
wire [ 7:0] spi_csn_s;
// sys reset
assign sys_cpu_resetn = sys_resetn & sys_cpu_mem_resetn & sys_pll_locked;
// ethernet transmit clock
assign eth_tx_clk = (eth_tx_mode_1g == 1'b1) ? sys_125m_clk :
(eth_tx_mode_10m_100m_n == 1'b0) ? sys_25m_clk : sys_2m5_clk;
assign eth_phy_resetn = phy_rst_reg;
always@ (posedge eth_mdc) begin
phy_rst_cnt <= phy_rst_cnt + 4'd1;
if (phy_rst_cnt == 4'h0) begin
phy_rst_reg <= sys_pll_locked;
end
end
// gpio
assign gpio_i[63:11] = gpio_o[63:11];
assign gpio_i[10: 0] = gpio_bd_i;
assign gpio_bd_o = gpio_o[26:11];
// sysref
ad_sysref_gen i_sysref (
.core_clk (rx_clk),
.sysref_en (gpio_o[32]),
.sysref_out (rx_sysref));
// instantiations
assign spi_csn = spi_csn_s[0];
fmcjesdadc1_spi i_fmcjesdadc1_spi (
.spi_csn (spi_csn_s[0]),
.spi_clk (spi_clk),
.spi_mosi (spi_mosi),
.spi_miso (spi_miso),
.spi_sdio (spi_sdio));
altddio_out #(.width(1)) i_eth_tx_clk_out (
.aset (1'b0),
.sset (1'b0),
.sclr (1'b0),
.oe (1'b1),
.oe_out (),
.datain_h (1'b1),
.datain_l (1'b0),
.outclocken (1'b1),
.aclr (~sys_pll_locked),
.outclock (eth_tx_clk),
.dataout (eth_tx_clk_out));
system_bd i_system_bd (
.rx_core_clk_clk (rx_clk),
.rx_data_0_rx_serial_data (rx_data[0]),
.rx_data_1_rx_serial_data (rx_data[1]),
.rx_data_2_rx_serial_data (rx_data[2]),
.rx_data_3_rx_serial_data (rx_data[3]),
.rx_ip_data_data (rx_ip_data),
.rx_ip_data_valid (),
.rx_ip_data_ready (1'b1),
.rx_ip_data_0_data (rx_ip_data[63:0]),
.rx_ip_data_0_valid (1'b1),
.rx_ip_data_0_ready (),
.rx_ip_data_1_data (rx_ip_data[127:64]),
.rx_ip_data_1_valid (1'b1),
.rx_ip_data_1_ready (),
.rx_ip_sof_export (rx_ip_sof),
.rx_ip_sof_0_export (rx_ip_sof),
.rx_ip_sof_1_export (rx_ip_sof),
.rx_ref_clk_clk (ref_clk),
.rx_sync_export (rx_sync),
.rx_sysref_export (rx_sysref),
.sys_125m_clk_clk (sys_125m_clk),
.sys_25m_clk_clk (sys_25m_clk),
.sys_2m5_clk_clk (sys_2m5_clk),
.sys_clk_clk (sys_cpu_clk),
.sys_cpu_clk_clk (sys_cpu_clk),
.sys_cpu_reset_reset_n (sys_cpu_mem_resetn),
.sys_ddr3_cntrl_mem_mem_a (ddr3_a),
.sys_ddr3_cntrl_mem_mem_ba (ddr3_ba),
.sys_ddr3_cntrl_mem_mem_ck (ddr3_clk_p),
.sys_ddr3_cntrl_mem_mem_ck_n (ddr3_clk_n),
.sys_ddr3_cntrl_mem_mem_cke (ddr3_cke),
.sys_ddr3_cntrl_mem_mem_cs_n (ddr3_cs_n),
.sys_ddr3_cntrl_mem_mem_dm (ddr3_dm),
.sys_ddr3_cntrl_mem_mem_ras_n (ddr3_ras_n),
.sys_ddr3_cntrl_mem_mem_cas_n (ddr3_cas_n),
.sys_ddr3_cntrl_mem_mem_we_n (ddr3_we_n),
.sys_ddr3_cntrl_mem_mem_reset_n (ddr3_reset_n),
.sys_ddr3_cntrl_mem_mem_dq (ddr3_dq),
.sys_ddr3_cntrl_mem_mem_dqs (ddr3_dqs_p),
.sys_ddr3_cntrl_mem_mem_dqs_n (ddr3_dqs_n),
.sys_ddr3_cntrl_mem_mem_odt (ddr3_odt),
.sys_ddr3_cntrl_oct_rzqin (ddr3_rzq),
.sys_ethernet_mdio_mdc (eth_mdc),
.sys_ethernet_mdio_mdio_in (eth_mdio_i),
.sys_ethernet_mdio_mdio_out (eth_mdio_o),
.sys_ethernet_mdio_mdio_oen (eth_mdio_t),
.sys_ethernet_rgmii_rgmii_in (eth_rx_data),
.sys_ethernet_rgmii_rgmii_out (eth_tx_data),
.sys_ethernet_rgmii_rx_control (eth_rx_cntrl),
.sys_ethernet_rgmii_tx_control (eth_tx_cntrl),
.sys_ethernet_rx_clk_clk (eth_rx_clk),
.sys_ethernet_status_set_10 (),
.sys_ethernet_status_set_1000 (),
.sys_ethernet_status_eth_mode (eth_tx_mode_1g),
.sys_ethernet_status_ena_10 (eth_tx_mode_10m_100m_n),
.sys_ethernet_tx_clk_clk (eth_tx_clk),
.sys_gpio_bd_in_port (gpio_i[31:0]),
.sys_gpio_bd_out_port (gpio_o[31:0]),
.sys_gpio_in_export (gpio_i[63:32]),
.sys_gpio_out_export (gpio_o[63:32]),
.sys_pll_locked_export (sys_pll_locked),
.sys_ref_clk_clk (sys_clk),
.sys_ref_rst_reset_n (sys_resetn),
.sys_rst_reset_n (sys_cpu_resetn),
.sys_spi_MISO (spi_miso),
.sys_spi_MOSI (spi_mosi),
.sys_spi_SCLK (spi_clk),
.sys_spi_SS_n (spi_csn_s));
endmodule
// ***************************************************************************
// ***************************************************************************