fix convergence tolerance so that points projected into a rational
polynomial surface end up much closer than LENGTH_EPS.
[git-p4: depot-paths = "//depot/solvespace/": change = 1906]
the same precedence as sqrt. Add the code to find naked edges, and
draw them highlighted on the model. And make the direction of trim
curves consistent, always ccw with normal toward viewer; so there's
no need to fix the directions before triangulating.
[git-p4: depot-paths = "//depot/solvespace/": change = 1903]
Add stubs for functions to perform Booleans, and get rid of mesh
stuff, including the kd tree accelerated snap to vertex (which
should not be required if the shell triangulation performs as it
should).
Also check that a sketch is not self-intersecting before extruding
it or whatever. This is dead slow, needs n*log(n) implementation.
[git-p4: depot-paths = "//depot/solvespace/": change = 1902]
just applies an offset to the DXF before exporting. Useful enough
to be worth the ugliness, though.
This is the stupid routines from SketchFlat, slightly reworked.
[git-p4: depot-paths = "//depot/solvespace/": change = 1866]
lets us export open curves, if the user drew them that way.
Also increase the limits on how many pwls we will generate for a
single curve.
[git-p4: depot-paths = "//depot/solvespace/": change = 1854]
some magic numbers. This would be trivial to break, but still more
difficult than patching the binary to skip the check...
[git-p4: depot-paths = "//depot/solvespace/": change = 1853]
where it was, move the export (DXF, PNG, STL) stuff to export.cpp,
and move the regen/solve stuff to generate.cpp.
[git-p4: depot-paths = "//depot/solvespace/": change = 1825]
Jonathan Westhues