set of coplanar faces. The polygon count still gets stupid fast;
I'm thinking I can fix that by adding some extra test planes at the
top of the 3d BSP, to quickly cull out stuff that doesn't intersect
us.
[git-p4: depot-paths = "//depot/solvespace/": change = 1736]
a triangle mesh in a BSP. That works, although it splits too often,
the initial triangulations are not good quality, and coplanar faces
are not yet handled. I'll do the coplanar thing tomorrow.
[git-p4: depot-paths = "//depot/solvespace/": change = 1735]
for that, and storing the triangles instead of rendering them
immediately. Not sure if that's smart; in theory could change from
implementation to implementation, but the results look much better
than I would get myself.
[git-p4: depot-paths = "//depot/solvespace/": change = 1733]
not very well; I'm doing a b-rep, where the boundaries are complex
polygons, and there's too many special cases. I should probably
replace this with a triangle mesh solution.
[git-p4: depot-paths = "//depot/solvespace/": change = 1731]
constraints work mod 180 degrees, so that it snaps to however the
workplane was drawn (more vertical vs. more horizontal).
[git-p4: depot-paths = "//depot/solvespace/": change = 1714]
workplanes. And fix up our polygon normals, so that everything gets
shaded correctly (and so that later we can generate our STL files
with correct normals).
[git-p4: depot-paths = "//depot/solvespace/": change = 1706]
faces of the polyhedron. And shade the faces when I draw them, and
fix up our projection matrix so that the depth testing works
properly.
[git-p4: depot-paths = "//depot/solvespace/": change = 1703]
issues, when the points are not all in the same coordinate system.
All painful, of course. Also add continuous line drawing, and
auto-constraining of line segments as I draw.
[git-p4: depot-paths = "//depot/solvespace/": change = 1683]
Jonathan Westhues